I run Kubuntu 18.04 and have been happily using version 2015.03-2 but decided to give the new version a shot. I followed the instructions from the downloads page, adding the PPA, updating, upgrade, etc. Nothing... Then "sudo apt install openscad" etc. but no offer of a new version appears. I was informed that I have the newest version. Did I miss a step?

algotruneman wrote > I run Kubuntu 18.04 and have been happily using version 2015.03-2 but > decided to give the new version a shot. > > I followed the instructions from the downloads page, adding the PPA, > updating, upgrade, etc. Nothing... Then "sudo apt install openscad" etc. > but no offer of a new version appears. I was informed that I have the > newest version. > > Did I miss a step? > > _______________________________________________ > OpenSCAD mailing list > Discuss@.openscad > http://lists.openscad.org/mailman/listinfo/discuss_lists.openscad.org Hi Algot, Your post didn't make it to the mailing-list. Your forum profile has your verizon email, in the mailing-list this is flagged "Delivery was disabled by the system due to excessive bouncing from the member's address", I see you also have your gmail address subscribed to the mailing-list. Please change your Forum profile to use gmail. Your questions will get visible. MichaelAtOz Forum Admin ----- Admin - email* me if you need anything, or if I've done something stupid... * click on my MichaelAtOz label, there is a link to email me. Unless specifically shown otherwise above, my contribution is in the Public Domain; to the extent possible under law, I have waived all copyright and related or neighbouring rights to this work. Obviously inclusion of works of previous authors is not included in the above. The TPP is no simple “trade agreement.” Fight it! http://www.ourfairdeal.org/ time is running out! -- Sent from: http://forum.openscad.org/

On 22.05.19 15:08, Algot Runeman wrote: > I followed the instructions from the downloads page, adding the PPA, > updating, upgrade, etc. Nothing... Then "sudo apt install openscad" etc. > but no offer of a new version appears. I was informed that I have the > newest version. > > Did I miss a step? No, it seems it's not yet updated. PPA and distribution releases are not part of the official release so it might take some time to catch up. Meanwhile the AppImage should run fine on 18.04 (provided it's a 64-bit installation as there's no 32-bit AppImage yet). ciao, Torsten.

The AppImage works for Ubuntu 18.10 64-bit. -- Sent from: http://forum.openscad.org/