DIY threads are a nightmare. Don't do that. Look for existing thread
libraries.
On Thu, Jul 21, 2022 at 5:37 PM Bogdan Caramalac via Discuss <
discuss@lists.openscad.org> wrote:
---------- Forwarded message ----------
From: fxeconomist@yahoo.com
To: discuss@lists.openscad.org
Cc:
Bcc:
Date: Thu, 21 Jul 2022 22:37:16 +0000
Subject: [OpenSCAD] Re: vise screw question
Hi Gene, did you manage to make the screw ? Could you share the code ?
I need a vise screw for my project but what gives me nightmares is the
fillet on the screw and its negative in the wall where it has to screw in.
It will be probably based on a zillion cylinders rotating slowly in a the
ZY plane while advancing on X linearly.
---------- Forwarded message ----------
From: Bogdan Caramalac via Discuss discuss@lists.openscad.org
To: discuss@lists.openscad.org
Cc: fxeconomist@yahoo.com
Bcc:
Date: Thu, 21 Jul 2022 22:37:16 +0000
Subject: [OpenSCAD] Re: vise screw question
OpenSCAD mailing list
To unsubscribe send an email to discuss-leave@lists.openscad.org
Do you know any that’s fairly simple to use ?