Is there an option to show debugging information on the command line? Not sure how to go about debugging this.
On Wednesday, February 16, 2022, 12:57:52 AM PST, Torsten Paul <torsten.paul@gmx.de> wrote:
Yes, there were a number of changes although nothing I can see,
that should have changed behavior.
Without anything specific, there's not much to say.
It would be interesting to see what's causing that.
ciao,
Torsten.
OpenSCAD mailing list
To unsubscribe send an email to discuss-leave@lists.openscad.org
Is there an option to show debugging information on the command line? Not sure how to go about debugging this.
On Wednesday, February 16, 2022, 12:57:52 AM PST, Torsten Paul <torsten.paul@gmx.de> wrote:
Yes, there were a number of changes although nothing I can see,
that should have changed behavior.
Without anything specific, there's not much to say.
It would be interesting to see what's causing that.
ciao,
Torsten.
_______________________________________________
OpenSCAD mailing list
To unsubscribe send an email to discuss-leave@lists.openscad.org
