Just checking account bounces. Thanks. --Algot

reply through forum as source. -- Sent from: http://forum.openscad.org/

Dear List, at the moment i am playing around with creating a OpenSCAD pretty printer to give my written code a better look. If you have Linux-64Bit you can test a demo application by downloading this: https://www.Corpsman.de/OpenSCAD_pretty_printer.tar.gz Actually this is a really raw and early stage (could not detect unary operands, missing tons of features ..) When finished i plan to have at least the following features: - run without gui - configure by passing a configurationfile - support Windows / Linux - Integration into OpenSCAD Finishing my tool to support the first 3 is not a problem. But integrating it into OpenSCAD is. So my question, is there out someone who is willing to do that ? In my wildest dream this should act like the following workflow. Open OpenSCAD, go to the options configure a external tool to call configure a key-binding for that tool (for this special one i like to choose CTRL+D) configure the params that where passed, this should be at least:  -filename of the current file in the editor  -To support some of my other ideas additionally it should be possible to pas the actual caret position to the called tool. Run it wihtin the IDE as often as needed. OpenScad then will do the following.  1. store the editor content to file  2. run the external tool  3. load the editor content from file  4. restore the caret position from before the key command. So what do you think ? Is there a chance to do that ? If not i will publish my tool anyway, but without OpenSCAD integration it would not be as nice as it could be. Best regards Corpsman