Hello OpenSCAD,
I don't know where to put this but it bit me again. The current help for the thread= parameter in screw_hole is:
thread thread type or specification for threaded masks, or false to make an unthreaded mask. See screw pitch. Default: false
Adrian pointed out to me that I should have thread=true in my last run in with no threads in my screw hole. This time I was able to refer back to that discussion and get past the problem
How about putting something in the help for thread=true?
Thanks and thanks for the help of this group.
Bob Roos
--
Best regards,
Bob mailto:roosbob@wybatap.com
The right place to post about something like this---anything that you think
is a bug in BOSL2 or a suggestion that doesn't warrant some kind of broad
discussion---is to open a github issue on the BOSL2 github page.
I have changed the documentation text to say:
thread = thread type or specification for threaded masks, true to make a
threaded mask with the standard threads, or false to make an unthreaded
mask. Default: false
Does that address it?
On Sun, Mar 12, 2023 at 11:11 PM Bob Roos roosbob@wybatap.com wrote:
Hello OpenSCAD,
I don't know where to put this but it bit me again. The current help
for the thread= parameter in screw_hole is:
thread thread type or specification for threaded masks, or false to make
an unthreaded mask. See screw pitch. Default: false
Adrian pointed out to me that I should have thread=true in my last run in
with no threads in my screw hole. This time I was able to refer back to
that discussion and get past the problem
How about putting something in the help for thread=true?
Thanks and thanks for the help of this group.
Bob Roos
--
Best regards,
Bob mailto:roosbob@wybatap.com
OpenSCAD mailing list
To unsubscribe send an email to discuss-leave@lists.openscad.org
Hi Adrian,
perfect. thanks.
I will check into GitHub. I admit that it confuses me m I try to avoid it.
Bob
Sunday, March 12, 2023, 11:20:00 PM, you wrote:
The right place to post about something like this---anything that you think is a bug in BOSL2 or a suggestion that doesn't warrant some kind of broad discussion---is to open a github issue on the BOSL2 github page.
I have changed the documentation text to say:
thread = thread type or specification for threaded masks, true to make a threaded mask with the standard threads, or false to make an unthreaded mask. Default: false
Does that address it?
On Sun, Mar 12, 2023 at 11:11 PM Bob Roos roosbob@wybatap.com wrote:
Hello OpenSCAD,
I don't know where to put this but it bit me again. The current help for the thread= parameter in screw_hole is:
thread thread type or specification for threaded masks, or false to make an unthreaded mask. See screw pitch. Default: false
Adrian pointed out to me that I should have thread=true in my last run in with no threads in my screw hole. This time I was able to refer back to that discussion and get past the problem
How about putting something in the help for thread=true?
Thanks and thanks for the help of this group.
Bob Roos
--
have Fun,
Bob mailto:roosbob@wybatap.com