[OpenSCAD] DXF for cut and engrave

Troberg troberg.anders at gmail.com
Tue Oct 22 02:28:03 EDT 2019


How I do this: I make each color a separate object. So, one cut object, one
engrave object in most cases. Then, I export them separately, stack them in
Lightburn, and then set the settings for each color and burn.

To make it easier to see while working in OpenSCAD, I offset the cut layer 1
mm in Z.

It would be nice if it could be done simpler, but this is the best way I
found.



--
Sent from: http://forum.openscad.org/



More information about the Discuss mailing list