[OpenSCAD] Hooks and grooves?

Ronaldo Persiano rcmpersiano at gmail.com
Sat Oct 5 16:42:40 EDT 2019


Some slanted finger joints, perhaps.

A sábado, 5/10/2019, 19:23, Matthias Urlichs via Discuss <
discuss at lists.openscad.org> escreveu:

> On 04.10.19 17:13, John Lussmyer wrote:
> > I've been using simple dovetail joints.
>
> Umm, well, for a somewhat-removeable lid (which doesn't slide off on its
> own when mounted upside down – I need them for an enclose of a
> ceiling/corner-mounted room monitor) these are probably not the right
> choice. I'm looking for something that locks with a snap-in and doesn't
> require tight tolerances.
>
> Of course I know about Thingiverse, but I didn't find anything remotely
> suitable.
>
> --
> -- Matthias Urlichs
>
>
> _______________________________________________
> OpenSCAD mailing list
> Discuss at lists.openscad.org
> http://lists.openscad.org/mailman/listinfo/discuss_lists.openscad.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openscad.org/pipermail/discuss_lists.openscad.org/attachments/20191005/4195610f/attachment.html>


More information about the Discuss mailing list