[OpenSCAD] Discuss manifoldness, co-incident faces edges etc

arnholm at arnholm.org arnholm at arnholm.org
Wed Nov 13 04:58:00 EST 2019


On 2019-11-13 09:56, nop head wrote:
> OpenSCAD isn't artificially enforcing a restriction. It is implemented
> in a way that doesn't allow non-manifold geometry.

Some use cases *require* non-manifold topology.
This type of software is not just for 3d printing even if that was the 
origin.

Carsten Arnholm



More information about the Discuss mailing list