[OpenSCAD] Any thoughts on using units other than millimeters?

A. Craig West acraigwest at gmail.com
Sun May 19 13:38:50 EDT 2019


I was just going to recommend the same thing, wrap the whole design in a
scale statement

On Sun, 19 May 2019, 12:52 adrianv, <avm4 at cornell.edu> wrote:

> I'm not quite sure I understand:  are you modeling something in inches that
> you need to output to a device that uses millimeters?
>
> Why not just wrap your whole model with a scale() to (optionally?) change
> the output scale as required, e.g. scaling up by 25.4 if you need to have a
> model in inches processed into mm.
>
>
>
> --
> Sent from: http://forum.openscad.org/
>
> _______________________________________________
> OpenSCAD mailing list
> Discuss at lists.openscad.org
> http://lists.openscad.org/mailman/listinfo/discuss_lists.openscad.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openscad.org/pipermail/discuss_lists.openscad.org/attachments/20190519/e4302dd2/attachment.html>


More information about the Discuss mailing list