[OpenSCAD] Any thoughts on using units other than millimeters?

adrianv avm4 at cornell.edu
Sun May 19 12:51:34 EDT 2019


I'm not quite sure I understand:  are you modeling something in inches that
you need to output to a device that uses millimeters?  

Why not just wrap your whole model with a scale() to (optionally?) change
the output scale as required, e.g. scaling up by 25.4 if you need to have a
model in inches processed into mm.  



--
Sent from: http://forum.openscad.org/



More information about the Discuss mailing list