[OpenSCAD] "Too many unnamed arguments "

lar3ry lar3ry at sasktel.net
Tue May 14 16:06:11 EDT 2019


Of course! Rookie mistake.
In my defense, I will say that what got me confused was the change in
behaviour from my previous rev of OpenSCAD. Previously, the only result of
that error would have been that the translate would not have given an error
message, but would have shown up as a failure to do the translation.
I think I prefer the old way, but that error message will not throw me
again.
Thanks, guys.




--
Sent from: http://forum.openscad.org/



More information about the Discuss mailing list