[OpenSCAD] How can I make a phase on a cube just on on side

Ezra Reynolds shadowwynd at gmail.com
Fri May 3 08:16:51 EDT 2019


Hull works by wrapping smaller shapes as if with plastic wrap for food.

For a cube, this means putting eight shapes (One for each corner).

> On May 3, 2019, at 8:08 AM, ats3788 <ats3788 at gmail.com> wrote:
> 
> Thank you very much
> I don't understand in the Moment how that works but I try !!!
> 
> 
> 
> --
> Sent from: http://forum.openscad.org/
> 
> _______________________________________________
> OpenSCAD mailing list
> Discuss at lists.openscad.org
> http://lists.openscad.org/mailman/listinfo/discuss_lists.openscad.org



More information about the Discuss mailing list