[OpenSCAD] 3D model for stamp fabrication

cbernhardt charlie at carols62.com
Wed Jul 31 05:54:06 EDT 2019


Fram wrote
> In general, I want this to work for any 2D geometry, not just text. I need
> to
> convert vector graphics into printing plates. 

Renaldo's Minkowski method will also work with an extruded DXF file.  The
attached picture is an example taken from your DXF file.  A much more
elegant solution than my approach.  Just hope you have a fast computer.
<http://forum.openscad.org/file/t1309/russian6.jpg> 




--
Sent from: http://forum.openscad.org/



More information about the Discuss mailing list