[OpenSCAD] 3D model for stamp fabrication

Frank van der Hulst drifter.frank at gmail.com
Tue Jul 30 02:18:23 EDT 2019


If you do a linear_extrude of each letter separately, you may be able to
control the distortion adequately?

On Tue, 30 Jul 2019, 17:13 Fram, <valkrsk at gmail.com> wrote:

> Unfortunately scale works with respect to single point in the model. This
> leads to distortion (see the attached picture).
> <http://forum.openscad.org/file/t2613/3.png>
>
>
>
> --
> Sent from: http://forum.openscad.org/
>
> _______________________________________________
> OpenSCAD mailing list
> Discuss at lists.openscad.org
> http://lists.openscad.org/mailman/listinfo/discuss_lists.openscad.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openscad.org/pipermail/discuss_lists.openscad.org/attachments/20190730/0f0a1a38/attachment.html>


More information about the Discuss mailing list