[OpenSCAD] Rounding tops of lettering

cbernhardt charlie at carols62.com
Wed Jul 24 12:13:24 EDT 2019


I am looking for a method to “round” the top part of the lettering shown in
the attached picture.  The letters have a slight taper toward the top of the
lettering, but the tops are flat.  Instead of having the top of the
lettering flat, I would like to have the tops rounded.  I can produce a DXF
or STL file of just the outline of the top of the lettering.  Any
suggestions?  

<http://forum.openscad.org/file/t1309/lettering.jpg> 



--
Sent from: http://forum.openscad.org/



More information about the Discuss mailing list