[OpenSCAD] General approach
nate-openscadforum at pedantic.org
Mon Jul 8 11:37:24 EDT 2019
> ... So the extended discussion of the internals is interesting and
worthwhile but my original intent on the thread was to see if what I was
doing made sense geometrically. Similar to the thread about taking apart
the three cones that were joined. ...
The stuff in the original post doesn't seem correct to me. It seems like
you're confusing rotation by 180 degrees with reflection.
Can you try using:
"rotate (v=[0,1,0], a=180)"
Sent from: http://forum.openscad.org/
More information about the Discuss