[OpenSCAD] STL triangles inside a cube

cbernhardt charlie at carols62.com
Sat Sep 15 07:17:12 EDT 2018


fred_dot_u wrote
> If the outside of the car body is one contiguous surface, (or even if it
> isn't), you might be able to use Meshmixer to perform the task. .......

Thanks.  I have used the Meshmixer Plan Cut feature.  The project I have in
mind would require almost 20 "cuts", so I was hoping there was a less
complicated solution.
Charles




--
Sent from: http://forum.openscad.org/



More information about the Discuss mailing list