[OpenSCAD] spout

Troberg troberg.anders at gmail.com
Thu Sep 13 07:18:42 EDT 2018


Without knowing how the spout should look, it's very hard to give advice.

Some possible ways:

* Make a cone with cylinder(), hollow it out with difference() and anther
cone.

* Start with a cube, difference out bits you don't want.

* Make 2D shapes and extrue or rotate extrude them

Either way, you'll probably have to add some attachment bits and remove some
bits you don't need.

If you could post some kind of sketch or picture, it would be so much easier
to give good suggestions.



--
Sent from: http://forum.openscad.org/



More information about the Discuss mailing list