[OpenSCAD] module [maybe later function] spiral(rev, hfac, wfac, base_r, sp_r)

r.d. terramir terramircomputers at gmail.com
Sun Sep 9 22:45:01 EDT 2018

Well what I did is actually working albeit I had to change some stuff to
negative cause it was winding in the wrong direction. I got the cutout for
the spring I did a wall test print and with a little prep it worked.
So now just design the battery box to go with it.

On Sep 8, 2018 7:06 PM, "NateTG" <nate-openscadforum at pedantic.org> wrote:

> If you want to do the angles in degrees instead, you can just replace 360
> with 1.
> Lines 42-46 and then 63-72 make the tapered windings.
> It's possible to do fancier stuff to get something that looks better, but
> I'm not sure what application you have in mind.
> --
> Sent from: http://forum.openscad.org/
> _______________________________________________
> OpenSCAD mailing list
> Discuss at lists.openscad.org
> http://lists.openscad.org/mailman/listinfo/discuss_lists.openscad.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openscad.org/pipermail/discuss_lists.openscad.org/attachments/20180909/b6163dec/attachment.html>

More information about the Discuss mailing list