[OpenSCAD] Round shapes created in openscad are not smooth but hexigonal

Rob Ward rl.ward at bigpond.com
Sat Sep 1 05:33:31 EDT 2018


.STL in mm is just a very happy coincidence, or someone's very good anticipation for an important technology. Thanks folks!!
Cheers, RobW

On 1 September 2018 7:00:33 pm AEST, nop head <nop.head at gmail.com> wrote:
>STL is unit-less also. It is the slicer in a 3D printing chain that
>decides
>1 unit is 1mm.
>
>On 1 September 2018 at 09:30, FourthDr <who_doctor at hotmail.com> wrote:
>
>> Export to STL seems to be in mm. But I didn't set any units.
>>
>>
>>
>> --
>> Sent from: http://forum.openscad.org/
>>
>> _______________________________________________
>> OpenSCAD mailing list
>> Discuss at lists.openscad.org
>> http://lists.openscad.org/mailman/listinfo/discuss_lists.openscad.org
>>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openscad.org/pipermail/discuss_lists.openscad.org/attachments/20180901/946fd3ca/attachment.html>


More information about the Discuss mailing list