[OpenSCAD] Head light bezel

Glenn West glennswest at neuralcloudcomputing.com
Tue Jan 16 19:37:40 EST 2018


Out a line at that point and use a hull 
You can tilt the line 


Sent from my iPhone

> On 17 Jan 2018, at 12:58 AM, cbernhardt <charlie at carols62.com> wrote:
> 
> I am working on a project to 3D print a headlight bezel for an old Corvette. 
> I have the main part designed in OpenSCAD (see attached picture), but I need
> to figure out how to measure/design/integrate the part shown in the yellow
> circle on the picture.  Any suggestions?
> <http://forum.openscad.org/file/t1309/bezel.jpg> 
> 
> 
> 
> --
> Sent from: http://forum.openscad.org/
> 
> _______________________________________________
> OpenSCAD mailing list
> Discuss at lists.openscad.org
> http://lists.openscad.org/mailman/listinfo/discuss_lists.openscad.org




More information about the Discuss mailing list