[OpenSCAD] FW: Rendering problem about importing dxf file

cbernhardt charlie at carols62.com
Fri Jan 12 15:11:49 EST 2018


ericlau:

I'm not sure if this matters in your application, but you might like to
know.  Your DXF file contains what AutoCAD calls a "POLYLINE".  In your case
the POLYLINE is a series of connected line segments.  POLYLINES can also
contain connected line segments and arc segments, but OpenSCAD cannot
properly display the arc  segments unless you "EXPLODE" the POLYLINE into
separate lines and arcs.  I changed the line segments in your DXF file into
arc segments and imported it into OpenSCAD.  You can see the difference in
the picture below.
Charles
<http://forum.openscad.org/file/t1309/arcs_lines.jpg> 



--
Sent from: http://forum.openscad.org/




More information about the Discuss mailing list