[OpenSCAD] Fw: Re: 3D Printer

fred fred_dot_u at yahoo.com
Tue Apr 24 19:33:34 EDT 2018


If you're shooting for nylon, you'll also want to know that nylon filament is seriously hydroscopic. It can absorb atmospheric water in as little as a day, compared to PLA or ABS which is good for a week or more. Keep the nylon sealed when not in use. Print your part and remove the nylon immediately, unless a repeat print is in the works.
 
The stuff expands a good ten percent after its printed, depending on the original dimensions.
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openscad.org/pipermail/discuss_lists.openscad.org/attachments/20180424/100985be/attachment.html>


More information about the Discuss mailing list