[OpenSCAD] Approach to recreate this in OpenSCAD?

MichaelAtOz oz.at.michael at gmail.com
Thu Oct 27 17:08:50 EDT 2016


Scalpel78 wrote
> Hi, I've made this sensor holder in Autodesk Fusion 360, but now I want to
> make it in OpenSCAD instead.
> 
> Do you have hints as to what approach I should take? Start with a 2D
> figure, and extrude? Start with a 3D box, and cut out?
<http://forum.openscad.org/file/n18813/IMG_20161027_211542.jpg> 
I'd do a 2D of the 'wall' profile & extrude, add the slightly raised base of
the wall as flat cube()'s then prob hull() a few circle()s to get the radius
of the curves of the base and extrude (or you could hull flat cylinder()'s)



-----
Admin - PM me if you need anything, or if I've done something stupid...

Unless specifically shown otherwise above, my contribution is in the Public Domain; to the extent possible under law, I have waived all copyright and related or neighbouring rights to this work. Obviously inclusion of works of previous authors is not included in the above.

The TPP is no simple “trade agreement.”   Fight it! http://www.ourfairdeal.org/   time is running out!
--
View this message in context: http://forum.openscad.org/Approach-to-recreate-this-in-OpenSCAD-tp18813p18814.html
Sent from the OpenSCAD mailing list archive at Nabble.com.




More information about the Discuss mailing list