[OpenSCAD] if intersection ?
paperbot13 at gmail.com
Sat Oct 15 03:53:31 EDT 2016
Good idea. I need to experiment with that.
----- Reply message -----
From: "MichaelAtOz" <oz.at.michael at gmail.com>
To: <discuss at lists.openscad.org>
Subject: [OpenSCAD] if intersection ?
Date: Thu, Oct 13, 2016 9:07 pm
You could use projection()
of the intersection, then linear extrude your support. If the intersection
is empty there is nothing to extrude.
Admin - PM me if you need anything, or if I've done something stupid...
Unless specifically shown otherwise above, my contribution is in the Public Domain; to the extent possible under law, I have waived all copyright and related or neighbouring rights to this work. Obviously inclusion of works of previous authors is not included in the above.
The TPP is no simple “trade agreement.” Fight it! http://www.ourfairdeal.org/ time is running out!
View this message in context: http://forum.openscad.org/if-intersection-tp18700p18703.html
Sent from the OpenSCAD mailing list archive at Nabble.com.
OpenSCAD mailing list
Discuss at lists.openscad.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Discuss