[OpenSCAD] How can I tell what OpenSCAD is doing?

nop head nop.head at gmail.com
Mon Oct 10 10:46:43 EDT 2016


I can't test it because I don't have a an angle parameter but it seems like
it would make 360 1 degree slices of a torus and place them in a circle.
The problem is they will all be oriented at the same angle, so will not
join up to form a torus.

On 10 October 2016 at 15:14, Parkinbot <rudolf at parkinbot.com> wrote:

> nophead wrote
> > Going back to the OP, unless I misunderstand the intention, the slices
> > should be rotated into position, not translated with sine / cosine
> > coordinates.
>
>
> I would say the OP was a rotate_extrude with a twist. A similar question in
> an other thread was how to produce a satellite twist within a twisted
> linear_extrude.
>
>
>
>
> --
> View this message in context: http://forum.openscad.org/How-
> can-I-tell-what-OpenSCAD-is-doing-tp18632p18650.html
> Sent from the OpenSCAD mailing list archive at Nabble.com.
>
> _______________________________________________
> OpenSCAD mailing list
> Discuss at lists.openscad.org
> http://lists.openscad.org/mailman/listinfo/discuss_lists.openscad.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openscad.org/pipermail/discuss_lists.openscad.org/attachments/20161010/df9e6d1f/attachment-0002.html>


More information about the Discuss mailing list