[OpenSCAD] How can I tell what OpenSCAD is doing?

Parkinbot rudolf at parkinbot.com
Mon Oct 10 10:14:38 EDT 2016


nophead wrote
> Going back to the OP, unless I misunderstand the intention, the slices
> should be rotated into position, not translated with sine / cosine
> coordinates.

 
I would say the OP was a rotate_extrude with a twist. A similar question in
an other thread was how to produce a satellite twist within a twisted
linear_extrude. 




--
View this message in context: http://forum.openscad.org/How-can-I-tell-what-OpenSCAD-is-doing-tp18632p18650.html
Sent from the OpenSCAD mailing list archive at Nabble.com.




More information about the Discuss mailing list