[OpenSCAD] Can't figure out how to draw thin cylinders.

Parkinbot rudolf at parkinbot.com
Thu Jun 30 18:26:32 EDT 2016


You are perfectly right. As almost all tools downstream will interpret units
as mm, it's worth mentioning it, to prevent unexpected results. 

And if you remind  this discussion
<http://forum.openscad.org/strange-polygon-behaviour-in-small-scale-tp17390.html>  
it is not advisable to use very small values in OpenSCAD, because there is
some unexpected rounding "magic" going on behind the scenes. So it is not a
good idea to use inches for a design that is going to be specified in
fractions of inches. 



--
View this message in context: http://forum.openscad.org/Can-t-figure-out-how-to-draw-thin-cylinders-tp17841p17846.html
Sent from the OpenSCAD mailing list archive at Nabble.com.




More information about the Discuss mailing list