[OpenSCAD] STL without render?

Neon22 mschafer at wireframe.biz
Thu Jun 2 16:22:57 EDT 2016


As pointed out above. Nophead's solution of "hull between spheres at junction
points" is the least effort for speedup. You can set the sphere resolution
low ($fn) for faster preview.

The route best suited to your specific problem is extruding a cross sectiin
along a 'wire' for which there is code linked above. You' d make many
'wires' and then skin them, finally union these together if you needed a
single solid object.



--
View this message in context: http://forum.openscad.org/STL-without-render-tp17503p17535.html
Sent from the OpenSCAD mailing list archive at Nabble.com.




More information about the Discuss mailing list