[OpenSCAD] Negative Zero (-0)

william whareg12 at yahoo.com
Wed Jun 1 07:31:34 EDT 2016

I know it is perhaps a bit pedantic but I report it anyway just to see if it
is just an issue with my understanding. 

I tried to produce the -0 result as described in the documentation.  My
attempt was:


Should the last two echo results be "-0" instead of "0".  


View this message in context: http://forum.openscad.org/Negative-Zero-0-tp17502.html
Sent from the OpenSCAD mailing list archive at Nabble.com.

More information about the Discuss mailing list